Matters needing attention in the use of gantry grooving machine
1. Trial production should be conducted in advance before production. Formal production can only be carried out after several finished products are checked continuously and confirmed to be in accordance with the requirements. Pay attention to the observation in the production process, check the similar trial production process every five minutes, and stop the machine for adjustment if there is any problem
2. During the operation of the gantry planer, be careful, fasten the work clothes, avoid the knife edge, do not touch the moving parts with hands, and do not touch the buttons at will, so as to ensure the production safety.
3. Adjust accurately according to the required size, use tools when adjusting, be careful and pay attention to safety.
4. Pay attention during working hours, strictly abide by the operating procedures, and ensure safe operation.
5. Before work, the paper feeder should be adjusted to the same line and parallel to the work axis.
6. Cut off the power before adjusting the equipment.
7. Always check whether the parts are worn or not according to the requirements, and repair or replace them in time if there is any problem.
8. After adjusting the working size, check whether the locking part is locked, whether the chain is properly tightened, remove the miscellaneous items on the gantry planer, and then manually turn to check whether there is any abnormality.
9. When adjusting, pay attention to the use of a complete set of paper slitting knife with moderate gap and appropriate pressure of thread pressing wheel.
10. Pay attention to the maintenance and lubrication of the machine, ensure the oil level of the oil tank, and drip it frequently. The transmission slide of the feeder should be lubricated once every shift. The connecting gear should be lubricated frequently. The running bearing should be overhauled for half a year to a year. The grease should be filled with calcium base and adjusted
Keep the shafts clean and wipe them with engine oil frequently. After the completion of production, shut down according to the specified procedures, and then cut off the power supply. Wipe the machine every day at work, keep hands clean during work, and clean the surrounding environment after work.
11. Pay attention to the pressure between the corner cutting blade and the bottom shaft, take the slight cutting after the blade contacts with the paperboard as the criterion, and adjust slightly to avoid damaging the blade edge.
12. When the gantry groove planer is started, ensure the oil level of the exposed oil cup is appropriate, and then start the machine to run at low speed to observe whether the rotation is abnormal. When the transmission parts are fully lubricated and the machine does not rotate with abnormal sound, speed up the working speed and cause the failure