How to solve the abnormal reset of Mental Laser Cutting Machine?
Laser cutting machine is a modern commonly used processing equipment, and there will always be some headaches during the use process, especially the reset of the laser cutting machine is not normal. This is also a problem that everyone is more concerned about. The following is a brief introduction to the solution to the abnormal reset of the laser cutting machine.
How to solve the problem of abnormal reset?
1. Check if the sensor is dusty, bad contact or damaged (clean the dust on the sensor or replace it);
2. Check whether the flexible conductive tape data cable is in poor contact or damaged (trim the data cable and re-plug or replace the data cable);
3. Check whether the ground wire contact is reliable or the high voltage wire is damaged (reground or replace the high voltage wire);
4. Poor motor wire contact.