Reasons and treatment methods of plate rolling machine turning machine not turning
1. When rolling a narrow cylinder, it should be placed in the center of the roll.
2. After the work piece enters the roll, the hands and clothes should be avoided from being rolled into the roll.
3. Only when the work piece is placed stably and in the correct position before starting the operation, and the signal should be clear, and one person should be appointed to direct it.
4. The hand should not be placed on the rolled steel plate, and it is forbidden to use the model for viewing, and the model should be used to check the roundness after stopping.
5. When rolling a workpiece that is not round enough, when rolling to the end of the steel plate, a margin should be reserved to prevent the workpiece from falling and hurting people.
6. It is forbidden to stand on the workpiece during work, nor to find the roundness on the rolled cylinder.
7. When the roll is thick, the cylinder with large diameter or the workpiece with high data strength, the moving roller should be lowered a few times and subjected to repeated roll forming.